HOOKE’S LAW Archives | School Portal NG

Hooke’s law states that “the extension of a spring is proportional to the applied force, provided that the force is not large enough to deform the spring permanently”. Mathematically expressed as Force α extension. Spring constant Since Force α extension then Force / Extension constant (k). The constant of proportionality (k) is called the spring constant. F / e k or Force (N) k e. The spring constant is a measure of the stiffness of a spring. The greater the constant the stiffer the spring. The spring constant varies with the following;- a) Material – identical springs mad of different materials will have different constants i.e.steel and copper. b) Diameter – the stiffness decreases with the increase in diameter. c) Thickness of the wire – a spring made of a thicker wire is stiffer than the one made of thin wire of the same material. d) Length of spring – a short spring is stiffer than a longer one. e) Number of turns per unit length – a spring with higher number of turns per unit length is less stiff than the one with fewer turns per unit length. Example If the springs shown below are similar and the constant of proportionality (k) is 100 Nm-1, determine total extension in each arrangement. The spring balance It is made up of a spring mounted in a metal or plastic casing. The spring is fitted with a pointer which moves along a calibrated scale divided into ten equal parts. Examples A load of 4 N causes a certain copper wire to extend by 1.0 mm. Find the load that will cause a 3.2 mm extension on the same wire. (Assume Hooke’s law is obeyed). Solution F α e also F1 / F2 e1 / e2 F2 (4 × 3.2) / 1.0 12.8 N. 2. A body of 200 g was hung from the lower end of a spring which obeys Hooke’s law. Given that the spring extended by 100 mm, what is the spring constant for this spring? Solution F α e, F k e. F 200 × 10-3 kg × 10 N /kg 2 N. Extension 100 × 103 m 0.1 m. Spring constant (k) 2 / 0.1 20 N/m. Two identical springs, whose spring constant is 6.0 N/cm, are used to support a load of 60 N as shown below. Determine the extension of each spring. Solution Since the springs are parallel their spring constant equals 2k. Therefore extension Force / k 2 F / k 60 / 2 × 6 5 cm. Each spring will extend by 5 cm. See also: MAGNETIC EFFECT OF AN ELECTRIC CURRENT REFLECTION AT CURVED SURFACES EQUILIBRIUM AND CENTRE OF GRAVITY TURNING EFFECT OF A FORCE MEASUREMENT II

HOOKES LAW