GROWTH AND DEVELOPMENT

GROWTH AND DEVELOPMENT

Concept of Growth and Development

Growth is a characteristic feature of all living organisms. Most multicellular organisms start life as a single cell and gradually grow into complex organisms with many cells. This involves multiplication of cells through the process of cell division. This quantitative permanent increase in size of an organism is referred to as growth. For growth to take place the following aspects occur

 

Cells of organisms assimilate nutrients hence increase in mass. Cell division (mitosis) that lead to increase in the number of cells. Cell expansion that leads to enlargement an increase in the volume and size of the organism. It is therefore possible to measure growth using such parameters as mass, volume, length, height, surface area.

 

On the other hand development is the qualitative aspect of growth which involves differentiation of cells and formation of various tissues in the body of the organism in order for tissues to be able to perform special functions. It is not possible to measure ac aspects of development quantitative. Therefore development can be assessed terms of increase in complexity of organism e.g. development of leaves, flowers and roots.

 

A mature human being has millions of cells in the body yet he or she started from; single cell, that is, a fertilised egg. During sexual reproduction mammals an ovum fuses with a sperm form a zygote. The zygote divides rapidly without increasing in size, first into 2, 4, 8, 16,32, 64 and so on, till it forms a mass cells called morula.

These first cell division is called cleavages. The morula develops a hollow part, resulting into a structure known as a blastula (blastocyst). Later, blastocyst cells differentiate into an inner layer (endoderm) and the outer layer (ectoderm). The two-layered embryo implants into the uterine wall and, by obtaining nutrients from the maternal blood, starts to grow and develop.

 

BlastocoeJ Fertilised egg 2-celled stage 4-celled stage {zygote) Morula Blastula (mass of cells) As the embryo grows and develops, changes occur in cell sizes and cell -types. Such changes are referred to as growth and development respectively. These processes lead to morphological and physiological changes in the developing young organism resulting into an adult that is more complex and efficient.

 

In the early stages, all the cells of the embryo look alike, but as the development process continues the cells begin to differentiate and become specialised into different tissues to perform different functions. Growth involves the synthesis of new material and protoplasm. This requires a continuous supply of food, oxygen, water, warmth and means of removing waste products.

 

In animals, growth takes place all over the body but the rates differ in the various parts of the body and at different times. In plants however, growth and cell division mostly take place at the root tip just behind the root cap and stem apex. This is referred to as apical growth which leads to the lengthening of the plant.

However, plants do not only grow upwards and downwards but sideways as well. This growth leads to an increase in width (girth) by the activity of cambium cells. The increase in girth is termed as secondary growth.

 

Measurement of growth

Growth can be estimated by measuring some aspect of the organism such as height, weight, volume and length over a specified period of time. The measurements so obtained if plotted against time result into a growth curve.

 

A sigmoid curve may therefore be divided into four parts.

Lag phase (slow growth)

This is the initial phase during which little growth occurs. The growth rate is slow due to various factors namely: (i) The number of cells dividing are few. (ii) The cells have not yet adjusted to the surrounding environmental factors.

 

Exponential phase (log phase)

This is the second phase during which growth is rapid or proceeds exponentially. During this phase the rate of growth is at its maximum and at any point, the rate of growth is proportional to the amount of material or numbers of cells of the organism already present.

 

This rapid growth is due to:

(i) An increase in number of cells dividing, 2-4-8-16-32-64 following a geometric progression,

(ii) Cells having adjusted to the new environment,

(iii) Food and other factors are not limiting hence cells are not competing for resources,

(iv) The rate of cell increase being higher than the rate of cell death.

 

Decelerating Phase

This is the third phase during which time growth becomes limited as a result of the effect of some internal or external factors, or the interaction of both.

 

The slow growth is due to:

(i) The fact that most cells are fully differentiated.

(ii) Fewer ceils still dividing,

 

Environmental factors (external and internal) such as:

  • Shortage of oxygen and nutrients due to high demand by the increased number of cells.
  • Space is limited due to high number of cells.
  • Accumulation of metabolic waste products inhibits growth. limited acquisition of carbon (IV) oxide as in the case of plants.

 

Plateau (stationary) phase

This is the phase which marks the period where overall growth has ceased and the parameters under consideration remain constant.

This is due to the fact that:

  1. The rate of cell division equals the rate of cell death.
  2. Nearly all cells and tissues are fully differentiated; therefore there is no further increase in the number of cells.
  3. The nature of the curve during this phase may vary depending on the nature of the parameter, the species and the interns! Factors.
  4. In some cases, the curve continue to increase slightly until organism dies as is the case monocotyledonous plants, man invertebrates, fish and certain reptiles indicates positive growth.
  5. In some cases the curve flattens out indicating change in growth while other growth curve may tail off indicating a period of negative growth rate.
  6. This negative pattern characteristic of many mammals including humans and is a sign of physical senesce associated with increasing age.

 

EVALUATION

  1. What is difference between growth and development?
  2. What are the 4 main types of growth and development?
  3. What is the example of growth and development?
  4. What is growth and development introduction?
  5. What is the relationship of growth and development?
  6. What are three differences between growth and development?
  7. What are the 7 stages of growth and development?

 

See also

FERTILIZATION IN ANIMALS

REPRODUCTION IN ANIMALS

METHODS OF FRUIT AND SEED DISPERSAL

POLLINATION

SEXUAL REPRODUCTION IN PLANTS

SUBSCRIBE BELOW FOR A GIVEAWAY

Do You Like Our Lesson? Please Leave A Comment Below ↓

Leave a Comment

Your email address will not be published.

error: Content is protected !!
Exit mobile version