Skip to content
Agricultural Science

A fish pond is an artificial body of water in which fishes are reared for commercial purposes. There are various yes of fish pond. It is a confined body of water where fishes are raised under controlled conditions. Fish can also be raised in plastics, fiber stars and wooden rafts.

There are three types of pond:

  1. Earthen pond
  2. Concrete pond
  3. Plastic pond

 

EARTHEN POND

This involves digging the soil usually clay (25 %clay) to a depth ranging from 0.5- 1.0 m at shallow end and 1.5 – 2.0m at the drain end to raise fish. Pond can be of any shape as long as it is well constructed. However rectangular or square shapes are considered the best. This is usually practicable in swamping environment. This rule away the problem of water maintenance as there is natural flow in and out of water in the pond

 

(i) Excavated Pond

An excavated pond is often built on level terrain and its depth is achieved solely by excavation.  An excavated pond is relatively safe from flood damage, is low maintenance and can be built to expose a minimum water surface area in relation to volume. This is beneficial in areas of high evaporation losses and a limited amount of water supply. Ponds should have gentle slopes on dikes as depicted in the Figure below

 

(ii) Embankment Pond

This type of pond is built by creating an embankment or dam used to impound water and is usually constructed in a valley or on gently sloping land. It is not recommended to build an embankment pond on greater than a 4% slope. Less excavation may be needed to build this type of pond.

  1. CONCRETE POND

Here, 4-5 coaches of blocks are used to construct the pond above the ground level, using cement, sand and gravel in ratio 1:2:4 respectively with water. The pond floor should be well concreted to a thickness between 7.5cm- 10cm. Wall should be plastered to a thickness of 5cm. Water tap should be well connected to allow free flow in and out of water. This particular type has the advantage of you monitoring the hygiene of your fishes.

 

  1. PLASTIC POND

Pond construction is expensive and this has led many entrants to fish farming in Nigeria to build concrete tanks or to buy plastic tanks as production units. These are smaller units but are believed to be easier to manage as production units. Nigerian farmers have limited land and tank fish farming adapts well to their conditions than larger, more expensive earthen ponds. It is also noted that the quantity of fish harvested from such smaller production units is more easily marketed than harvests from large fish ponds. There are different shapes and sizes of tanks used, as shown below:

 

ESTABLISHMENT OF FISH POND

Factors to be considered before the establishment of fish pond

  1. Adequate water supply water could be obtained from boreholes, streams or lakes. Gravity flow water is cheapest and best source. The water must be unpolluted, uncontaminated. Borehole waters can be excellent, but may costly to pump and may require conditioning to remove carbon dioxide and improve oxygen content and temperature levels. Open waters from canals and streams may be polluted or be contaminated from runoff from farm lands or towns. Waters used in aquaculture need to be tested for quality e.g. water with alkalinities less than 30 ppm (CaCO3) will require liming to bring up pH levels close to neutrality (7.0) for best fish production
  2. Soil in the area: Soil with enough clay content to hold water. Clay and silty clays are excellent soils for holding water because they stop water from seeping through. Clay should make up at least 20-25% of the soil. The soil should be checked for residual chemicals from previous farm activities which could have effect on the fish health.
  3. Vegetation of the area
  4. Topography of the area: Topography that allows for economical construction. It directly affects building costs and pond management. Pond should be constructed where enough water can be impounded with the least amount of earth fill. Areas with large shallow water should be avoided because they become too shallow to use during the dry season.
  5. Availability of fast growing fish species
  6. Availability of supplementary feedstuff
  7. Nearness to market: There should be a fish market near-by to allow for high capacity of sale of fish from pond harvests. The market requirement is the first requirement for locating a fish farm. This will further help address issues relating to transportation of the fish to the market.

 

STEPS IN ESTABLISHING FISH POND

  1. Site selection: This involves the choice of best site based on necessary conditions like, a piece of land through which a perennial stream flows. Other factors to consider before sitting a fish pond are
  2. General survey: Detailed survey of the chosen site should be carried out, especially by extension workers.
  3. Clearing and stumping of site: This involves removal of trash, cutting of trees and removal of stumps.
  4. Construction of dam: This is usually constructed across the stream. Clay soil should be used for dam construction because of its ability to hold water.

 

EVALUATION

  1. Define the following:
  1. Site selection
  2. General survey
  1. a. Which soil is best used for dam construction?
  1. State four properties of the soil

 

  1. Construction of core trench: This involves the removal of the soil or excavation. It is positioned at right angle to the dam.
  2. Construction of spill way: Spill way is positioned at one end of the dam. It is constructed using a wood and wire-meshed screen.
  3. Impoundment of pond: This involves the filling of the pond with water by opening the monk board of the reservoir.
  4. Liming: This involves the addition of limestone or calcium carbonate powder to the sides and bottom of the pond to seal pores and prevent water loss.
  5. Pond fertilization: This is done by pouring organic fertilizers such as poultry droppings, cow dung or in-organic fertilizers such as N:P:K or super phosphate. Pond fertilization should be done 15 days before stocking pond with water.
  6. Pond inoculation: This is the introduction of proper planktons species into the pond. This is done by obtaining some water from a plankton rich pond and pour into a newly fertilized pond.
  7. Stocking of pond: This is introduction of the proper baby fish called fingerlings or fries into the pond.

 

STEPS IN CONSTRUTING A FISH POND

  • Choose a suitable site considering nearness to market, road accessibility, topography, soil type (clay), availability of feed supplement etc
  • Clear the vegetation on the land
  • Mark out pond area
  • Dig out pond to required depth (1-2m) ensure pond bottom slops towards outlet to help drainage during harvesting
  • Construct drainage system consisting of outlets and ditches
  • Construct water inlet at the shallow end.
  • Construct pond wall with mixture of clay and sand
  • Seal pond bottom with clay
  • Grass the embarkment to prevent soil erosion
  • Construct duke around the pond mouth to prevent inflow of run-off water.
  • Fence pond with net to ward off pests.

 

EVALUATION

  1. Mention four factors that should be considered when siting a fish pond
  2. Explain six ways of maintaining a fish pond (WASSCE 2003 question 7a).
  3. Describe the construction of a fish pond (WASSCE 2004 question 8a).
  4. State three factors that influences the choice of suitable site for fish (WASSCE 2013 question 7 b).

 

MAINTENANCE OF FISH POND

To ensure the continuous availability of fish in a pond or to maintain high yield of fish, the following activities should be carried out:-

  1. Regular feeding: The fish should be fed twice daily from a selected point. Supplementary feeds should be given in sufficient quantity to ensure rapid growth and early maturity of the fish.
  2. Constant water supply: The pond should be supplied with water to the fullest. The water should be clean and free of odour.
  3. Deweeding: Weeds should be removed from the pond. This allows the dissolution of oxygen, penetration of sunlight to the bottom of the pond for the use of the planktons and preventing the buildup of pests and diseases in the pond.
  4. Aeration: Adequate aeration should be provided as it enables oxygen to dissolve in water which is required by fish for respiration. Fish normally comes to the surface due to little or no oxygen in the water in some ponds.
  5. Desilting: This is the removal or prevention of silt from entering the water. Desilting promotes easy movement of water, makes the water to be clean and prevent pollution of the water.
  6. Control of predators: Predators like snakes or birds should not be given access to the pond as they could eat up the fishes on the pond surface.
  7. Disease prevention: Disease should be prevented by adequate feeding, stocking, weeding, manuring of the pond. Sticking to these measures will prevent the attack of diseases.
  8. Application of fertilizers: Fertilizers should be applied once in a month as this promotes the growth of planktons in the pond.
  9. Regular Harvesting: Fish should be harvested regularly to prevent over population, outbreak of disease and cannibalism.

 

EVALUATION

  1. Outline 9 maintenance cultures of ensuring continuous availability of fish in a pond.
  2. Outline 5 ways of harvesting fish
  3. State 5 ways of preserving fish.
  4. List 5 basic laws and regulations of fishery in Nigeria.
  5. Explain how each of the following practices can bring about high fish yield from a fish pond
  6. Deweeding
  7. Desilting
  8. Supplement feeding
  9. Fetilization (WASSCE 1990 question 8).

 

WEEKEND ASSIGNMENT

  1. Which of the following are the cheapest methods of preserving fish? a. salting and sun drying freezing and chilling c. salting and canning d. smoking and canning.
  2. Which of the following is the major function of an air-pump in an aquarium
  3. eliminating fish waste from the aquarium b. supplying oxygen to the fish in the aquarium d. eliminating foul odour from the aquarium.
  4. In ponds, fish is usually caught with the following except a. trawler b. cast net c. fish trap d.hook and line.
  5. Which of the following is the reason for smoking fish? a. removing parasites b. preserving it c.increasing its flavour d. decreasing its flavour.
  6. Which of the following pond maintenance operation will ensure adequate supply of oxygen and hygienic conditions for fish in a pond? a. deweeding b. desilting c. fertilization d.eradication of predators

 

THEORY

  1. Explain five fishery regulations being used in Nigeria.
  1. Explain how each of these practices can bring about high yield from a fish pond.
  2. deweeding b. desilting. c. supplementary feeding d. fertilization.
  3. Describe five factors required for establishing a fish pond
  4. Enumerate six management practices for maintaining high fish yield (WASSCE 1989 question 7).

 

See also

FISH FARMING

AGRICULTURAL EXTENSION

ANIMAL NUTRITION

LIVESTOCK MANAGEMENT

LIVESTOCK MANAGEMENT

SUBSCRIBE BELOW FOR A GIVEAWAY

More Suggestions

Leave a Reply

Your email address will not be published. Required fields are marked *